lince
级别: *
精华主题: * 篇
发帖数量: * 个
工控威望: * 点
下载积分: * 分
在线时间: (小时)
注册时间: *
最后登录: *
查看lince的 主题 / 回贴
楼主  发表于: 2008-07-25 08:25
运动控制CPU软件 MT-DEVELOPER / SW6RNC-GSVE安裝后出現沒有找到SSCPDR6.dll 不能啟動,我已經重裝系統了,還是不行。有沒有人知道系統不兼容處理。
daizhi
一师一地一时一法
级别: VIP会员

精华主题: 0
发帖数量: 1470 个
工控威望: 1376 点
下载积分: 3900 分
在线时间: 2976(小时)
注册时间: 2007-05-31
最后登录: 2023-11-27
查看daizhi的 主题 / 回贴
1楼  发表于: 2008-07-25 09:28
1) SNETP is not installed. Even if communication with the CPU is not made actually, SNETP must be installed. Refer to section 3.1 "Installation" to install the SW6RN-SNETP (Ver. 00B or later. If communication is made only with the Q172/Q173CPU, install SW6RN-SNETP.
• A list of applications for communication with the CPU is displayed. The following applications cause the phenomenon described to the left. (Applications other than those listed below operate without SNETP.)
GSV[ ][ ]P : Monitor, communication, program editor, install, mechanical system editor, test, backup, servo data setting (for writing to servo amplifier)
SW6RN-DOSCP: Digital oscilloscope
2) SNETP has been installed but is incompatible with the package given on the left. (SW6RN-SNETP (Ver. 00B or later) has been installed.) Refer to "3.7 Updating Instructions and Procedures" and update one set of SW6RNC-GSVE.
3) The PATH specified as the long name has been described in AUTOEXEC.BAT.
*: Long name: Folder name of 9 or more characters
Describe the SNETP PATH before the PATH specified as the long name, and always add "%PATH%" before the part where the long name has been specified. It is not required if it has already been described.
(Example)
• Before change SET PATH="C:\ProgramFiles\ABC;" (*1) SET PATH=%PATH%;C:\PROGRA~1\Sw6Sne~1; (*2)

• After change SET PATH=%PATH%;"C:\PROGRA~1\Sw6Sne~1;"SET PATH=%PATH%;"C:\ProgramFiles\ABC;"
*: Always described the (wiggly line) part.
(*1): Long name PATH
(*2): SNETP PATH
daizhi
一师一地一时一法
级别: VIP会员

精华主题: 0
发帖数量: 1470 个
工控威望: 1376 点
下载积分: 3900 分
在线时间: 2976(小时)
注册时间: 2007-05-31
最后登录: 2023-11-27
查看daizhi的 主题 / 回贴
2楼  发表于: 2008-07-25 16:18
SW6RN-SNETP 安装没有?